简体中文
EnglishCauses of hot pressing plate deformation of Jiangmen seamless hot press
Jiangmen seamless hot press when the fire pressure, due to the dual effect of temperature and pressure, then the hot plate will present some cracks, deformation and other phenomena, sometimes due to uneven temperature caused by the limit of the rough plate after sanding, there will be some white spots, some places are soft, hard layer thickness uneven phenomenon, so that the product quality is greatly affected.
The deformation of hot pressed plate of Jiangmen seamless hot press is mostly transverse and longitudinal
1. When the hot press is heated, the heating is uneven, and the temperature is too high during preheating. Generally, the deformation is easy to occur when the machine is started up in cold state.
2. The steam pipe in the hot pressed plate is blocked, and the uneven heating conduction will also lead to the deformation of the hot pressed plate.
3. The hot pressing plate deformation caused by the concentrated pressure on the thickness gauge.
4. If the hot press is not published smoothly and the operator does not find it in time, the pressure rise of the hot press will easily cause the bending deformation of the hot press plate.
All of the above are the reasons for the deformation of the hot pressing plate of the hot press. Do you understand all of them? If you have any questions, you can contact us, we will give you a detailed introduction.
Article source: Jiangmen seamless hot press /
-
12-25
What are the functions of Guangdong seamless hot press cushion
With the rapid development of China's economy, wood-based panel has also completed a huge leap, and the key equipment to complete wood-based panel production skills is hot press. Hot press particleboard, plywood category widely used, today and we discuss the use of hot press cushion. Cushion is generally required in the process of pressing laminate flooring, particleboard, melamine veneer, wooden door and furniture by hot press. In the operation combination of hot press, the buffer pad is clampe
-
12-25
Main structure of Guangdong seamless hot press
In the hydraulic oil system of veneer hot press, the current trend is that more and more oil is used as the medium, because it is more convenient to operate and complete automatic control, and its various control elements are standardized and serialized, providing convenience. In the multi-layer press, the combination of pressure storage tank and pump is used more and more recently to achieve higher closing speed. In terms of heating system, steam heating and electric heating are still commonly
-
12-25
Cleaning method of Guangdong seamless hot press production line
Before cleaning the production line of veneer hot press, the staff should be ready to clean things and seal the power supply of the equipment together. The hot pressing plate surface also needs to be cleaned, which will also extend its service life. When cleaning, it is necessary to check the oil filling part of the equipment in time to see if there is any oil leakage. Every day before production also want to check veneer hot press production line has no abnormal situation. The amount of water v
-
12-25
How to heat Guangdong seamless hot press
Heating method of seamless hot press: mainly related to temperature selection, technical control and product quality. Traditional heating methods: steam heating and electric heating are usually used. Steam heating has some problems, such as uneven plate temperature, while electric heating has the characteristics of large power consumption and working cost. Later, there were heat transfer oil heating methods. This heating method has high heat capacity, uniform temperature and small heat loss, so